Monster Non-Reduced
Sharp from every angle, the Mitre Cut assumes the lead. Sometimes it’s called the Slash Cut...but whatever...it is simply unmistakable. Use the Mitre Cut to shoot the exhaust gases skyward to easily clear the payload and headboard. Avoid the common blow-back effect where buffeting wind actually works against the exiting exhaust gasses. Power on in confidence...
Monster Setup
T909 Kenworth - 8" Monster Setup
T909 Kenworth - 8" Monster Setup
The Silverback 350C Series is suited for any truck built PRIOR to EURO-V or the YEAR 2010.
These Stacks ENDURE temperatures up to 350°C.
NON-REDUCED STACKS need to be used in a MONSTER SETUP.
These slip over the TAPERLOC end of the CENTRE SPOOL.
24" [610mm] |
30" [760mm] |
36" [915mm] |
48" [1220mm] |
54" [1370mm] |
60" [1525mm] |
64" [1625mm] |
72" [1830mm] |
6" |
7" |
8" |
The chart below displays the stock codes for the different stack variations.
It is good to refer to these stock codes at any point of enquiry.
|
5" |
6" |
7" |
8" |
24" |
MS5024AP |
MS6024AP |
- |
- |
30" |
- |
- |
MS7030AP |
MS8030AP |
36" |
MS5036AP |
MS6036AP |
MS7036AP |
MS8036AP |
48" |
MS5048AP |
MS6048AP |
MS7048AP |
MS8048AP |
54" |
MS5054AP |
MS6054AP |
MS7054AP |
MS8054AP |
60" |
MS5060AP |
MS6060AP |
MS7060AP |
MS8060AP |
64" |
MS5064AP |
MS6064AP |
MS7064AP |
MS8064AP |
72" |
MS5072AP |
MS6072AP |
MS7072AP |
MS8072AP |
This is a carefully applied coating that has been formulated to endure the acidic conditions the ad-blue creates. Generally applied to 350C Series when heat from the DPF is not an issue.
When ordering please include Part No. ADBL